Metallic floss question...

[SSgt Sketch]

So I recently started a project that is using a considerable amount of metallic floss. I was having trouble with the ends of the floss unraveling as I was stitching. I found that a small amount of super glue prevents this from happening. Considering that I am using the method of doubling one strand to make two strands with a loop (if that makes sense) the glue never stays in contact with the cloth (and eventually gets cut off). This is a big project and I would hate to find out later that this will somehow ruin my project. To sum it all up, is using the super glue on the floss a bad idea? Thank you in advance for the input.

[DMLC]

Expect some waste from metallic flosses. It can't be helped!!
Only major tip is to use shorter lengths of the floss.
I wouldn't use super glue!!

[kuja.girl]

ugh I feel your pain metalic thread can be a pain. I'd avoid super glue in the future because it is not archival (meaning it won't last 100 years without damage). I'd avoid glue altogether... it only makes a mess.

Here's some advice that I have found helpful:
- When stitching with metallic thread or metallics mixed with floss: fold the thread to make a loop, then insert the looped end into the needle; pull the ends through the loop and tighten, pulling the thread snug up against the eye of the needle. - You are basically making a slip knot around the eye of the needle and will need to cut it off when you are done. But it helps with the tension.

- Use shorter lengths of thread and stitch with a larger size needle - metallic thread is textured and tends to catch on the fabric and other threads, this helps avoid snarls.

I personality prefer to mix a strand (or two) of metallic with a strand (or two) of cotton thread. The intended effect is still there but it makes stitching a lot easier.

[SephreniaMusic]

I'm soon to begin stitching quite a lot with gold metallic thread so I'm glad I read this thread.